The same slope built as a column of two plates with a side stud and one headlight brick between them Three red slopes in a row forming one continuous slope, held by headlight bricks, one of them lying on its back The same slope built as a column of two headlight bricks with a plate with a side stud between them

LEGO Grammar

It’s called Grammar so the maths doesn’t scare anyone off.

A small guide to building LEGO sideways. It shows, one picture at a time, why a part turned on its side stops lining up, and how to make it fit.

Start with lesson 0, or see all the lessons.

The problem, in one picture

Stand two bricks one stud apart and try to fill the slot between them with plates standing on edge. Two go in. A third does not, and a sliver is left over.

That sliver is half a plate thick. It is the reason parts turned on their side never quite line up, and most of sideways building is about dealing with it.

20Two plates on edge leave 4 LDU of a 20 LDU column unfilled (3D view)
Blue, two plates on edge in a slot one stud wide. Orange, the sliver that is left.

What you will find here

Each lesson takes one question a builder runs into, shows the answer in a picture, and gives the short sum behind it, so you can check a build before you make it or order parts for it.

Tile on a side-stud brick sits one plate proud (3D view)
The question. A tile pressed onto the side of a brick sticks out past it, and nothing beside it will sit level.
Bracket wall plus plate plus tile fills one stud (3D view)
The answer. Use a bracket instead of the brick and add one plate. The face of the tile now lands exactly on the edge of the next stud.

The lessons

Lesson 0 is an introduction for anyone who has only ever stacked bricks. The course is the ten lessons after it, from the grid to what the sums cannot tell you. Jump in wherever your question is.

Tools and look-ups

Where it began