The fill to learn first: five plates laid on their side are exactly two studs wide.
- starting part
- sideways plates and tiles
- part doing the conversion
- the dimension being matched
Start with a brick that has a stud on its side. Press four plates onto that stud, one after another, and finish with a tile so that the outer face is smooth. Each of the five is 8 LDU thick.
Forty LDU is two studs exactly, so the face of the tile ends on the edge of the second stud column. A brick or a plate standing beside it is level with it.
Any multiple of five works the same way: ten plates on their side are four studs.

The gap underneath
The stack is level with the top of the brick, but its lower edge stops 4 LDU above the floor. The side stud is 10 LDU below the top of the brick and the plates reach 10 below that: 20 in all, on a brick that is 24 tall.
Four LDU is 1.6 mm, and a stud is about 1.7 mm tall, so a stud will not fit in that gap. Put a tile under the stack, not a plate with studs.
