Lessons7 · Less than a stud

Half a stud

A jumper plate moves everything above it half a stud sideways, which is how a 1-wide part is centred on a 2-wide one.

A jumper is a plate two studs long with a single stud in the middle of it, between the two places where studs would normally be. Whatever you press onto that stud sits half a stud to one side of the grid: 10 LDU.

That is how a part one stud wide is centred on a part two studs wide, and why windows, noses and aerials so often stand on jumpers.

Shifts add up. A second jumper on top of the first shifts another 10 LDU, and the build is back on the grid, one whole stud over.

Jumper plate shifts the next layer by half a stud (3D view)
A jumper under a brick: the brick sits 10 LDU to one side of the stud columns below it.

The sideways version

The same shift exists for side studs: a 1 × 2 brick with one side stud in the middle of its long face (86876). Before that part existed, builders pushed a half pin into a 1 × 2 Technic brick to get the same centred side stud.

A 1 × 2 brick with one stud in the middle of its long side
The 1 × 2 brick with one side stud in the middle of its long face (86876).