Lessons10 · Before you order

Gaps and lips

Two traps that the sums predict and builders still forget.

The gap under a sideways part

On a brick with a side stud, the stud is 10 LDU below the top. A part one stud wide pressed onto it reaches 10 above the stud and 10 below: level with the top of the brick, and 4 LDU short of its underside.

That gap is too low for a stud, which is 4 LDU tall with nothing to spare. Fill it with a tile, hide it behind something, or use a plate with a side stud instead, which comes out level at the bottom.

4A tile on an 87087 leaves a 4 LDU gap above the floor (3D view)
The gap under a tile on a brick with a side stud.

The lip of the headlight brick

A headlight brick has a hole in its back that takes a stud, so one headlight brick can be pushed onto the side stud of another. The right way up, it does not go: the lip under the first brick’s side stud is exactly where the second brick’s back wall has to be.

Turn the second brick upside down and it fits, resting on the lip instead of fighting it.

Two headlight bricks, both the right way up, seen from the front. The second, orange, is pushed onto the side stud of the first as far as it will go: its back wall meets the lip and it stops short, with a gap left between the two bricks
A headlight brick pushed upright onto another. In the side view the marked overlap is the back wall meeting the lip; in 3D the orange brick has stopped 4 LDU short.