Lessons5 · A smooth sideways wall

The headlight brick

The headlight brick is the other part that supplies half a plate. It is a 1 × 1 brick whose side stud is sunk 4 LDU into the brick, so whatever is pressed onto it sits half a plate further in than it would on an ordinary brick with a side stud.

Its measurements

Three numbers describe it. The face around the side stud is sunk 4 LDU into the brick. Under the stud, a lip 4 LDU deep and 4 LDU high comes back out to the edge. Behind the stud, the body is 16 LDU deep: exactly two plates.

Headlight brick (3D view)
A headlight brick in side view and in 3D. The dashed outline is a tile on its side stud.

Half-plate steps

Tile on a headlight brick sits half a plate proud (3D view)
A tile on a headlight brick ends 4 LDU outside the stud column.
Tile on a side-stud brick sits one plate proud (3D view)
The same tile on a brick with a side stud ends 8 LDU outside. Use one of each side by side and the two faces differ by half a plate.

Two builds that use it

Four headlight bricks interlock into a 40 by 40 LDU square (3D view)
Four headlight bricks, each with its side stud pushed into the underside of the next, close into a square 40 LDU on a side: two plates and three plates in each direction.
An inverted headlight brick plugs onto a headlight stud and rests on the lip (3D view)
A headlight brick pushed onto another’s side stud by the hole in its back only fits upside down, where it rests on the lip. The right way up, the lip is in the way.

The red slope in lesson 3 is built on the same part: one headlight brick lying on its back gives the half plate that lines the three slopes up.