Lessons8 · Studs underneath

Studs on two opposite faces

When one assembly has to show studs on both faces at once, these are the shortest ways to build it.

Some parts of a model need studs on both faces at once: a wing with detail above and below, a floor that is also a ceiling. The shortest way is a single brick with a side stud on two opposite sides (47905), laid on its side. One stud points up and the other down.

The bases of the two studs are 20 LDU apart, the width of the brick. Twenty is two and a half plates, so when one face is on the plate grid the other is half a plate off. Decide which face may be the odd one before you build around it.

Brick with studs on two opposite sides, laid on its side (3D view)
A brick with two opposite side studs, on its side: studs up and down, 20 LDU apart.

The table lists the other ways the sources describe, with what each costs.

Other ways to put studs on both faces, as described in the sources
MethodPartsThicknessSource
Ring plate, thinPlate 1×1 with Clip Light Type 14081aRing 4 LDU; two plates on it total exactly 20LDraw geometry
Ring plate, thickPlate 1×1 with Clip Light Type 24081bRing 8 LDU; two plates on it total 24LDraw geometry
Blaster with studs on four facesMinifig Gun Blaster with Studs on Sides, Bottom and Front447091½ plates between side studsBrickNerd, LDraw
Technic plate and two-stud plateTechnic Plate 1×4 with HolesPlate 1×4 with Two Studs and Groove4263 + 417403 platesBrickNerd
Finger hinge platesHinge Plate 1×2 with 3 Fingers and Hollow Studs42751 studBrickNerd
Round tile with hole and 2×2 jumperTile 2×2 Round with HolePlate 2×2 with Groove with 1 Centre Stud15535 + 87580Not statedBrickNerd
Bar with stop ring between hollow studsBar 2L with Thick Stop and Pin HolesPlate 1×1×0.66778258 + 86996Not statedBrickNerd
Centred bracket, studs one face, anti-studs the otherBracket 2×2 – 1×2 Up Centred41682Wall 8 LDUBrickNerd, LDraw
Technic brick with a half pin each sideTechnic Brick 1×1 with HoleTechnic Pin 1/26541 + 42741 studBrickNerd

Download CSV

Everything so far holds at right angles. For any other angle you need a hinge.