Nine smaller things that catch builders out, each with the part that causes it.
- gap or collision
- the part that does not fit
None of these shows up in a sum. Each card names the part that causes the trouble and what to do about it.
- Technic holes sit highThe centre of a Technic brick’s hole is slightly above where a side stud would be, to leave room for a stud underneath. BrickNerd gives 0.1 mm, Bill Ward about 0.2 mm. Use one method across a whole sideways panel.

- A stud in a Technic holeIt holds, but the hole cannot flex, so the fit is tight and stressed. Fine for one decorative stud, poor as structure.

- Not every bracket wall is half a plateThe 2 × 2 bracket 3956 and the centred bracket 41682 have walls a full plate thick, twice the usual 4 LDU. The drawing shows the three side by side. Bracket walls lists every exception.

- The thick ring plate4081b replaced the 4 LDU ring with an 8 LDU one. Anything on its faces is a quarter plate proud.


- The headlight has no clearanceLaid on its back, a headlight brick is exactly as tall as two plates to its stud face, with none of the usual 0.1 mm of clearance. A plate bridging the two sits tight, with no slack to absorb an error.

- Plates between studsThe gap between two studs is a touch narrower than a plate. Wedging a plate there stresses the studs; a tile is slightly thinner and is accepted.

- The half-plate gap under a brick with a side studAnything pressed onto its side stud stops 4 LDU above the underside of the brick. Fill it, hide it, or use a plate with a side stud, which comes out level at the bottom.

- Collisions hide in the lipOf the stud-reversal chains searched, 46 fail because a bracket wall or a lip meets the source. Count the wall before you count the studs.

- Panels changedThe 1×2×1 panel 4865b has extra material in its inner corner. Trapping parts inside it is tighter than with the old square-cornered mould.

From here on the site is tools and reference: try your own numbers, or look up a part.