Every bar and handle a clip can hold, with where each one sits relative to the studs.
A handle is a bar moulded onto a part. To make a hinge, pick a handle and a clip whose bar positions match: the same distance out and the same distance below the top.
- Plate 1×2, handle on the side48336, 2540The partner of the horizontal clip. Bar 20 LDU out from the stud row, 2 LDU below the top face.

- Plate 1×2, handle on the end60478Bar 20 LDU beyond the end stud, 2 LDU below the top face.

- Plate 1×2, handles on both ends18649Two bars 60 LDU apart: three studs from pivot to pivot.

- Plate 1×1, handles on opposite ends78257Two bars 40 LDU apart, 20 LDU either side of the stud.

- Round plate 1×1 with handle26047A side handle on a round plate: 20 LDU out, 2 LDU below the top face.

- Plate 1×2 with two handles3839Two bars, one past each short end: 26 LDU from the plate’s centre and 6 LDU below the top face.

- Plate 1×2, angled handles92692Three grip positions on one loop: a middle bar 40 LDU out and two more turned about 22°.

- Plate 1×2 with upright bar on an arm4623, 88072An upright bar beside the plate: 22 LDU out on the long arm (4623), 20 LDU on the short one (88072).

- Brick 1×1 with handle2921An upright bar 20 LDU out from the stud centre.

- Brick 1×2 with handle30236A horizontal bar 20 LDU out and 10 LDU below the top face, matching the brick with horizontal clip 60476.

- Tile 1×2 with handle2432A bar standing over a tile, 20 LDU above its top face and 6 LDU off the centre line.

- Round plate 1×1 with bar32828A bar pointing straight out from the plate, 2 LDU below the top face, ending 30 LDU from the stud centre.

- Plate 2×2 with octagonal bar frame30033, 75937Eight bars around a 2×2 plate, each 30 LDU from the centre and 2 LDU below the top face.

- Bar 3L and 4L87994, 30374Loose bars. One L is one stud, so they are 60 and 80 LDU long.

- Bar holder with handle23443A short tube with a bar across its end: a bar socket and a handle at right angles.

Fills, offsets, reversals and hinges are the whole method. Before you order parts, read the list of ways a build can still go wrong.