Sources and method

You should be able to check every number on this site. This page says where the dimensions come from, how the figures were made, and who deserves the credit.

The people this is built on

Writers I learned from

The links to each of these are in the list under Method.

Method

Part geometry: the LDraw parts library, read file by file from a public mirror. Stud positions and directions were extracted from each part, transcribed into a 2D cross-section model, and every assembly on this page was built in that model and tested for overlapping bodies and blocked studs. The eight reference cards that prompted this page were reproduced exactly by the model before anything else was generated.

Limits: the model is a cross-section, so it cannot see collisions in the third dimension, and it uses nominal dimensions without the 0.1 mm clearances. Build a chain once before ordering parts for fifty.