LessonsLesson 10 of 10

Before you order

What do the sums not tell me?

A sum that comes out even does not guarantee a build that works. This lesson is the list to go through before you order parts: gaps the sums predict but are easy to forget, chains that land on the grid on paper and collide in the hand, and parts that are not the size their name suggests.

What the sums leave out

Every sum on this site answers one question: where does the face or the stud end up? It says nothing about the rest of the part. A part can land in exactly the right place and still leave a gap under it, or need the space that another part already fills.

The drawing shows the commonest case. The tile is exactly where the sum says, level with the top of the brick, and there is still a gap half a plate high beneath it.

4A tile on an 87087 leaves a 4 LDU gap above the floor (3D view)
A tile on the side stud of a brick. The marked gap under it is 4 LDU high.

Four checks, not one

A sum is the first of four checks, and a build has to pass all of them.

Fit. Do the sizes line up? This is the only check a sum answers.

Connection. Is there something to hold the part: a stud in an anti-stud, a clip on a bar? Two faces that only touch are not joined.

Clearance. Is there room for the whole of each part, not only the face you measured?

Strength. Will it stay put? One stud holds less than two, a long panel hung sideways from a single stud can sag or pull off, and a part forced into place strains its neighbours.

The sums use design sizes. Real parts are moulded and vary a little from one to the next, so a build that is exact on paper can still be tight or loose in the hand.

A 1x1 plate plugged by its stud into the hole of Technic brick 6541
A stud in a Technic hole. The sizes line up and it connects, but the fit is tight and the hole cannot flex: it passes three checks and fails the fourth.

Connections that strain the parts

A few connections hold only by bending the plastic a little. Builders call those illegal, a word taken from a 2006 talk by the LEGO designer Jamie Berard on stressing the elements. This site flags them where they appear. Every chain in the collection of chains uses only a stud pressed into the underside of a part, on the grid, so none of them is illegal in that sense.

The sum tells you where a part would land. It does not tell you whether the part can go there: check the gap, the wall and the lip.

Brick with side stud 87087 beside Technic brick 6541: the hole centre sits slightly higher than the stud
A Technic brick, blue, beside a brick with a side stud. The hole and the stud are not at quite the same height: one of the traps under Other things to watch.

In a real set

Ford Model T, set 11376, 2026.

In the steering block, two bars plug into the square holes in the backs of two headlight bricks (4070), and a brick stands directly in front of their side studs. On paper the studs end exactly at the face of the brick. In plastic they stand a hair proud, so one headlight brick pushes its neighbour away and a gap opens.

Reported in New Elementary’s review of the set, which calls the connection illegal. The drawing shows the parts the review names, not the whole steering block.

Two headlight bricks side by side on a plate, a bar pushed into the square hole in the back of each, and a 1 by 2 brick standing tight against their two side studs
Grey, the two headlight bricks. Red, the bars in their backs. White, the brick against their side studs.

A build to try

You need two headlight bricks.

Try to push the hole in the back of one onto the side stud of the other, both the right way up. It will not go: the lip is in the way. Turn the second brick upside down and try again. It fits.

Two headlight bricks, both the right way up, seen from the front. The second, orange, is pushed onto the side stud of the first as far as it will go: its back wall meets the lip and it stops short, with a gap left between the two bricks
Two headlight bricks, one pushed onto the other the right way up. It stops short, as the orange brick shows.

In this lesson