LessonsLesson 8 of 10

Studs underneath

How do I put studs on the bottom, or on both faces?

Some models need studs underneath, or on both faces at once: a ship’s hull, a ceiling, a wing with detail above and below. Stud reversal means making studs point the opposite way from the rest of the model: building part of it upside down, or inverted. No single part does it cleanly, so it is done as a chain: a source with a side stud, sometimes a few spacer plates, then a converter laid on its side, whose own side stud now points down or back up.

A chain is judged by where its final stud lands. X is how far out from the centre of the source it sits, and Z is how high its base is above the underside of the source. Both are in LDU and both are read off the side view; the third direction, along the wall, does not enter the sums. A chain is useful when both land on the grid, because ordinary parts then connect to it without a gap. This section tests every combination: 448 chains were built, 46 collide with themselves, 317 land between columns, and 85 land on a stud column.

XZ
X is measured along the bottom, Z up the side. Here X is 40 and Z is 24.

What a chain looks like

Grey is the source: an upright brick with a stud on its side, part of the model you already have. White are two plates pressed onto that stud, standing on edge. Blue is the converter, a second brick with a side stud, pressed on last and so lying on its side.

Lying down, the converter’s own side stud points straight up. That orange stud is what the chain is for. Turn the converter over before pressing it on and the same stud points down.

A chain lands on the grid when its sum is a multiple of 20. A result half a plate off is not a failure: pair it with a second half-plate part and the error cancels.

A brick with a side stud, two plates on edge and a second brick with a side stud lying on its side, its stud pointing up
A chain of four parts, in side view and in 3D.

In a real set

Modern House, set 31153, 2024.

The wing has two wall lights. For each, a grey brick with a side stud (87087) is built into the wall. A black brick with studs on two opposite sides (47905) is pressed onto that stud by its underside, so it lies on its side: one of its studs now points up and the other down. A clear 1 × 1 tile goes on each.

This is a chain with no plates in it. Checked against the LDraw file of the set, a part-by-part copy of LEGO’s building instructions.

A brick with a side stud in a wall. A brick with studs on two opposite sides is pressed onto that stud and lies on its side, so one of its studs points up and the other down, with a tile on each
White, the brick lying on its side. Red, the two tiles: one the right way up, one upside down.

A build to try

You need two 1 × 1 bricks with a side stud and two 1 × 1 plates.

Press the two plates onto the side stud of the first brick, then press the second brick onto them by its underside, with its own side stud facing up. Stand a third brick beside the chain, two studs along: the new stud is exactly level with the stud on that brick.

A brick with a side stud, two plates on edge and a second brick with a side stud lying on its side, its stud pointing up
Two bricks with a side stud and two plates: a stud pointing up, two studs out.

In this lesson