Lessons9 · At an angle

The basic hinge

The basic hinge is a plate with a handle held by a plate with a clip. These are the positions it can take, and where the folded plate ends up in each.

Every drawing on this page reads the same way: the grey plate is fixed, the blue plate is the one that folds, and the orange dot is the pivot.

Flat, up and down

Clip and bar hinge laid flat. Shown twice in 3D: a plate with a handle and a plate with two clips, and the one-stud pair, a round plate with a handle and a plate with one clip
Flat. The two studs are 40 LDU apart, so the hinge bridges exactly one stud column and both plates stay on the grid.
Hinged plate standing, studs facing away. Shown twice in 3D: a plate with a handle and a plate with two clips, and the one-stud pair, a round plate with a handle and a plate with one clip
Folded up, studs facing outward. The back of the blue plate is 4 LDU beyond the edge of the grey one, and it starts 8 LDU above the grey plate’s top.
Hinged plate hanging, studs facing back. Shown twice in 3D: a plate with a handle and a plate with two clips, and the one-stud pair, a round plate with a handle and a plate with one clip
Folded down, studs facing back. The stud face is 8 LDU beyond the edge, and the blue plate starts 4 LDU below the grey plate’s underside.

Upside down, and part way

Snap the clip on the other way up and the blue plate lies flat with its studs pointing down: a stud reversal made with two parts.

Because the pivot is above the middle of the plate, the result is half a plate low: its studs start 4 LDU above the underside of the grey plate.

Clip plate attached upside down, studs down (3D view, plate with handle 48336 and plate with clip 61252)
The clip plate attached upside down, studs pointing down.

A clip hinge can stop anywhere between flat and upright. At 45° a plate one stud long reaches 14.1 LDU across and 14.1 up, which is neither a whole stud nor a whole plate.

So at 45° nothing lands on the grid. That is expected: an angled wall is held at its far end by a second hinge, not by a stud. Building a given angle shows which angles close up exactly.

Clip plate folded up 45 degrees on a plate with handle
The blue plate folded up 45°, in side view and in 3D.

Why clips, and not ball joints

Finger hinges and the small ball joints pivot at the middle of the plate’s thickness instead of 2 LDU above it, so a right-angle fold made with them lands a quarter plate off in both directions. New Elementary’s article on clip triangles shows how the lift of the clip lets clip plates form exact 3–4–5 triangles.

Plate 1 × 2 with ball joint, 14417
A small ball joint. It has no lift like the clip’s, so its right-angle fold lands off the grid.