LessonsLesson 9 of 10

At an angle

How do I fold, lean or slope?

When a wall has to lean, a roof has to slope or a panel has to fold flat, studs cannot do it: a part pressed onto a stud sits flat against the part below. This lesson is about the parts that can, where each one turns, and how to end up at the angle you want.

A clip on a bar is a hinge

A bar is a rod 3.18 mm thick. It is either a loose part or moulded onto a plate as a handle. A clip is a springy C-shaped grip that snaps onto a bar and can turn around it.

Put the two together and you have a hinge: one part stays where it is and the other folds around the bar.

Clip and bar hinge laid flat. Shown twice in 3D: a plate with a handle and a plate with two clips, and the one-stud pair, a round plate with a handle and a plate with one clip
Grey, a plate with a handle. Blue, a plate with a clip snapped onto the handle, lying flat. The orange dot is the point they turn about, the middle of the bar. In 3D the hinge is shown twice: two on two, a 1 × 2 plate with a handle (48336) and a 1 × 2 plate with two clips (60470); and one on one, a round 1 × 1 plate with a handle (26047) and a 1 × 1 plate with a clip (61252). Both fold about the same point.

Where the pivot is

To know where a folded part will end up you need one fact: where it turns. On a plate with a handle, and on a plate with a sideways clip, the pivot is in the same place: 20 LDU out from the centre of the stud, and 6 LDU above the underside of the plate.

A plate is 8 LDU thick, so its middle is at 4. The pivot is 2 LDU above the middle, and that small lift decides where everything lands.

A clip hinge pivots 2 LDU above the middle of its plate. That small lift is why a right-angle fold lands on the half-plate grid.

Hinged plate standing, studs facing away. Shown twice in 3D: a plate with a handle and a plate with two clips, and the one-stud pair, a round plate with a handle and a plate with one clip
The blue plate folded straight up, on the two-stud hinge and on the one-stud hinge. The orange pivot sits one stud out and a little above the middle of the grey plate.

In a real set

Modern House, set 31153, 2024.

The loveseat in the wing folds on the parts from this lesson. A 1 × 2 plate with two clips (60470) lies flat under the seat. A 1 × 2 plate with a handle (48336) is snapped into the clips and carries the backrest, a 2 × 4 tile, leaning 15° back from upright.

Checked against the LDraw file of the set, a part-by-part copy of LEGO’s building instructions.

A 1 by 2 plate with two clips lying flat, and a 1 by 2 plate with a handle snapped into the clips and leaning back, carrying a tile that forms the back of a seat
Grey, the plate with two clips. White, the plate with a handle. Red, the tile of the backrest.

A build to try

You need a 1 × 2 plate with a handle on its side and a 1 × 2 plate with two clips.

Snap the clips onto the handle and fold the second plate straight up. Hold a plate against its back: it stands half a plate beyond the edge of the first plate, exactly as the drawing says.

Hinged plate standing, studs facing away. Shown twice in 3D: a plate with a handle and a plate with two clips, and the one-stud pair, a round plate with a handle and a plate with one clip
A clip plate folded up on a plate with a handle.

In this lesson