Lessons8 · Studs underneath

How many plates between

How many plates go between a source and a converter so that the output stud lands on a stud column? This table answers it for every pair, using the sum for X from the previous page.

How to read the table

Find the part your model already has in the rows on the left: that is the source. Find the part you want to lay on its side in the columns along the top: that is the converter. The number where they cross is how many plates to put between the two.

Take the first row and the first column, two bricks with a side stud. The table says 2. Check it with the sum: 10 for the face of the source, 16 for two plates, 14 for the converter. That is 40, two studs exactly.

101614
The first cell of the table drawn out: 10 + 16 + 14 = 40.

A dash means that no number of plates from none to three makes that pair land on a stud. A green number works whether the new stud points up or down; an orange one works one way only.

How many plates to put between a source (rows) and a converter (columns) so the output lands on a stud column. Green: works up and down. Orange: works in one direction only. Struck: lands on the grid but collides.
Source ↓ / converter →Brick 1×1 with Stud on 1 Side
87087
Brick 1×1 with Headlight
4070
Plate 1×1×0.667 Half Round with Open Side Stud
3386
Brick 1×1×1.667 with Studs on 1 Side
32952
Bracket 1×1 – 1×1 Up
36840
Bracket 1×1 – 1×1 Down
36841
Bracket 1×1 – 2×1 Up
73825
Bracket 1×1 – 2×1 Down
79389
Brick 1×1 with Stud on 1 Side8708722000–0–
Plate 1×1×0.667 Half Round with Open Side Stud338622000–0–
Brick 1×1 with Headlight407000333232
Brick 1×1×1.667 with Studs on 1 Side3295222000–0–
Bracket 1×1 – 1×1 Up36840––222121
Bracket 1×1 – 1×1 Down36841––222121↓

Download CSV