Lessons10 · Before you order

Collisions the search found

Of the 448 stud-reversal chains, 46 cannot be built because two parts would have to occupy the same space. Two parts cannot be in the same place, however well the sum comes out.

The four below are typical, and each is drawn twice. The side view shows the parts pressed together, with the overlap marked. The 3D view shows what happens in your hands: the last part, in orange, pushed on as far as it will go and stopped by the part in its way. The caption names the parts and says what meets what.

A chain that collides, seen from the front. The last part, orange, is pushed on as far as it will go and stops short of the stud, held off by the part in its way
A headlight brick (4070), two plates, then a bracket two studs tall (79389) turned studs down: its long wall meets the foot of the headlight brick and it stops 20 LDU short of the stud. The sum lands on the grid, but the parts cannot occupy the same space.
A chain that collides, seen from the front. The last part, orange, is pushed on as far as it will go and stops short of the stud, held off by the part in its way
A brick with a side stud (87087), then a bracket (36841) turned studs down: its wall meets the foot of the brick and it stops 12 LDU short.
A chain that collides, seen from the front. The last part, orange, is pushed on as far as it will go and stops short of the stud, held off by the part in its way
A brick with a side stud (87087), then a bracket two studs tall (79389) turned studs up: its long wall meets the brick’s own top stud and it stops 28 LDU short.
A chain that collides, seen from the front. The last part, orange, is pushed on as far as it will go and stops short of the stud, held off by the part in its way
A headlight brick (4070), then an inverted bracket (36840) turned studs down: its wall meets the lip of the headlight brick and it stops 4 LDU short.